How do you measure a corner sofa?

First measure the long side of your corner sofa. This can be on either the left or right. Then measure the short side, followed by the depth of the sofa. Always measure across the furthest protruding points.

Enter the longest side under Length and the shortest side under Width. If both sides of your corner sofa are the same length, it does not matter which measurement you enter as the length or width.

Pay close attention to the depth. The depth of your corner sofa must be equal to or smaller than the stated depth of the cover. For example, if the cover is 90 cm deep and your corner sofa is 100 cm deep, the cover will not fit.

With Raffles Covers, the following applies: if the length, width and depth of your corner sofa are equal to or smaller than the corresponding dimensions of the cover, the cover will fit. Raffles Covers always provide sufficient room for a good fit. Under Suitable for on the product page, you will find additional sizing advice for the specific model.

Height is less critical. The cover does not need to reach the ground. For example, if the cover is H: 70 cm and your corner sofa is H: 90 cm, approximately 20 cm will remain between the bottom of the cover and the ground. This is still a suitable height. Approximately 2–20 cm of clearance between the cover and the ground is beneficial for air circulation and helps reduce condensation underneath the cover.

Our sizing advice: if in doubt, choose a cover that is slightly larger rather than one that is too tight. Approximately 1–5 cm of extra room in length or width is sufficient. This extra room does not need to be present on every side. A slightly roomier cover is easier to put on and remove. It also places less tension on the fabric, helping to reduce wear.

Not sure which size you need? Send us a photo of your corner sofa using the green WhatsApp button at the bottom right of the website. Please include the accurately measured length, width, depth and height in cm. We will be happy to help you choose the best-fitting cover.

Please note: 

The image with the product is always leading.